If the values you enter are not accepted, check above to make sure 'Project settings' is NOT selected. User Defined -Enter values for Maximum and Minimum to set a range. When the Project Settings are used Color map options are disabled. Project Settings -The color range set under the Global Settings option in the Console is used. if Level 0 has a cell size of 0.5x0.5m, Level 1 has cell size 1.0x1.0m, Level 2 has cell size 2.0x2.0m etc.).Īctivating 'Improve coverage' means that data from a lower resolution level is used to fill gaps in the grid of a higher resolution level.
The sounding grid is built up using multiple resolution levels (i.e. A color scheme is selected to depict differences clearly. Optionally a reference layer can be selected which the shows the difference between it and the active layer. Only available if 'Use DTM settings' is disabled. Select the attribute of the selected layer to be used for color coding. Select the layer to be used for color coding. The latter could be the design layer used to show the difference between two layers in a selected color scheme. When unchecked additional options are added to the dialog to allow definition of an alternative Layer, Attribute, and Reference Layer if applicable. When the box is checked you are electing to use the same layer and attribute that was set in the DTM dialog. If necessary press the sign to open the tree structure menu. It depends on the type of layer which settings need to be set. The setting of the layer selected in the Layers list above is visible. The 3D model can be manipulated as follows:
Point label terramodel windows#
Then click on to link the 3D model file (*.x) from the standard Windows File Open dialog. If Yes, select the computation from which its position is drawn. Icons in the Yellow box above open the Vessels page: VesselsĬlick on and then on each 'vessel' object in turn.įor each object, decide whether it should be shown. Icons in the Blue box above open the Objects page. Icons in the Red box above open the View page. Which page of this multi-page dialog depends on which command is selected: Customizing the DisplayĬlicking on any icon in the toolbar, or clicking on the 3D Objects menu item. Zooms in toward and out from the pivot point.Īlternatively use the commands available in the View menu: Rotate, Pan Horizontally, Pan Vertically, and Recenter. Otherwise the pivot is located on the DTM surface. If the click is on an object the pivot point is located on the object itself. Right click in the scene to set a new pivot point. Move the mouse up and down rotates the scene vertically about the same pivot point. Move the mouse left and right spins the scene about a pivot point.